FamilyGardenTrains
https://familygardentrains.com/forums/

Crimped aluminum for corrugated siding
https://familygardentrains.com/forums/viewtopic.php?f=27&t=107
Page 1 of 1

Author:  paulrace [ Fri Aug 03, 2018 9:30 am ]
Post subject:  Crimped aluminum for corrugated siding

A reader writes:

I have a crimper as displayed in the article bu does not crimp the aluminum as produced by your efforts. IS heating the metal as a requirement to produce the effect.

---------------------------------------------------

Thanks for getting in touch. I assume that you saw my article here: https://www.familygardentrains.com/prim ... _steel.htm

Are you saying you tried the crimpers with sheet aluminum pans like I did and they didn't work? Or did you try them with aluminum soda can material?

As George says here: http://www.girr.org/girr/tips/tips4/cheap_siding.html , baking ("annealing") the aluminum from soda cans makes it a easier to crimp.

I know several folks who have good results from soda cans using George's instructions for annealing, using a "self-cleaning" oven. If you don't have a self-cleaning oven, it doesn't work as well. Sorry about that.

I usually stick to salvaging aluminum serving pans, etc. At church meals, family potlucks, etc. I always try to save the lids, since they're flat and easier to work wth. If I had an emergency, I could buy a set of new pans, but it hasn't come to that. :-)

So my finished crimped aluminum is not nearly as heavy-duty as George's but it works and looks good, and doesn't stress my crimpers.

I hope this makes sense, even if it doesn't point to a specific solution that will work for you.

- Paul

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://phpbb.com/